I'm trying to resurrect a Dataproducts LZR650 laser printer that has
been lying idle for several years. Apart from paper pickup problems,
it is exhibiting the following fault:

http://members.optusnet.com.au/~fzab...650_100dpi.jpg (146KB)

Is this a problem with the toner cartridge? Are the thick black
stripes caused by the developer (?) roll?

Note that the printer identifies itself as a "HP Laserjet series II".
Note also that there is some minor ghosting approximately 9.5cm apart
(9.5cm = pi * diameter of drum). This ghosting is not visible in the
scanned image.


- Franc Zabkar
--
Please remove one 's' from my address when replying by email.

In message <(E-Mail Removed)>
Franc Zabkar <(E-Mail Removed)> wrote:

> I'm trying to resurrect a Dataproducts LZR650 laser printer that has
> been lying idle for several years. Apart from paper pickup problems,
> it is exhibiting the following fault:
>
> http://members.optusnet.com.au/~fzab...650_100dpi.jpg (146KB)
AFAICT, this could be one of the following things:
- Drum unit not being cleaned properly (cleaning blade dirty or damaged)
- Clean drum cleaning blade
- Replace drum unit
- Fuser rollers dirty or damaged
- Clean fuser rollers
- Check fuser rollers for damage
- No high voltage or damaged transfer corona wire (?)
- Check high-voltage system
- Check transfer corona wire (may be dirty)
- Check discharge wire/brush

Later.
--
Phil. | Acorn RiscPC600 Mk3, SA202, 64MB,
(E-Mail Removed) (valid address)| 6GB, video mods, 8xCD, framegrabber,
http://www.philpem.dsl.pipex.com/ | Ethernet (i3 Etherlan600), Teletext
Error 8472. Borg dumped.