Heres my computers specs.

Asus p4sp-mx Mother Board
Intel Celeron 2.4 GHZ CPU socket 478
256 MB Ram
40 Gig Maxtor DiamondMax Plus Hard Drive
The computer was running off the onboard VGA

Earlier today the computer would not turn off, so I turned off the power to
the wall.
Then later when I went to turn on the computer, the POST goes through ok, and
then I see the windows xp load up screen, then the screen goes blank for a
few seconds, and then the computer reboots and it runs in that loop until I
turn off the power. I've tried another socket 478 2.2 Pentium 4 cpu, a
different stick off ram, and the result Is the same. I've inserted an AGP VGA
Card and this does not help.
I've run chkdsk /r from the recovery console and was told that one error on
the hard disk was fixed.
I've run windows xp repair, and get just past the screens for regional and
product key settings, and then the thing just reboots, and the windows repair
process is restarted, again an endless loop.

I've attached a hard drive with an existing windows xp installation from
another computer with a socket 478 cpu in it, and the computer freeze's
during the windows xp welcom screen, I think that there are too many
differences between the machines for that to work.

The only think I have not tried yet is to swap out the power supply.

Hope someone might be able to help.

--
Message posted via WindowsKB.com
http://www.windowskb.com/Uwe/Forums....dware/200512/1

> Then later when I went to turn on the computer, the POST goes through ok,
and
> then I see the windows xp load up screen, then the screen goes blank for a
> few seconds, and then the computer reboots and it runs in that loop until
I
> turn off the power.

Try to do F8 and select "Do not reboot automatically on error"
or something like that and note the error...

My shot in the dark!

Mike

Mike Gleason Jr Couturier wrote:
>> Then later when I went to turn on the computer, the POST goes through ok, and
>> then I see the windows xp load up screen, then the screen goes blank for a
>> few seconds, and then the computer reboots and it runs in that loop until I
>> turn off the power.
>
>Try to do F8 and select "Do not reboot automatically on error"
>or something like that and note the error...
>
>My shot in the dark!
>
>Mike


Thanks for the help Mike, I've gone ahead and formated/reinstalled the system
and its working ok now, but i'll keep your suggestion in mind for the next
time.

Steve

--
Message posted via WindowsKB.com
http://www.windowskb.com/Uwe/Forums....dware/200512/1