the removable printhead on my canon s750 is clagged up
what is the best method to clean it up
i have run the printhead clean utility many times but to no avail
i can easily pull out the cradle that holds the carts
so how do i remove the gunge in it??

relloman

"rello" <(E-Mail Removed)> wrote in message
news:40baf371.22712909@news-server...
> the removable printhead on my canon s750 is clagged up
> what is the best method to clean it up
> i have run the printhead clean utility many times but to no avail
> i can easily pull out the cradle that holds the carts
> so how do i remove the gunge in it??
>
> relloman


Best for the Canon and a clogged printhead ? Small saucer receptacle of warm
water or Windolene (spray containers of dilute ammonia for cleaning windows)
to cover just a couple of millimetres leave for a bit and then blot dry on
tissue. This often works and may need to be repeated.
--
Inkylink JetTec UK Quality - Wot others wanna-be
Epson C64/ C84 Lighfast pigmented inks. R200/300,
RX500 (all with 30% more free patent chip)
Canon BCI-3 i560 i750 BCI-6 i865 S-820 / S-900 series.
Specialist ink refill kits... http://www.inkylink.co.uk
remove pants for personal mail

It's funny, the printhead on my Canon S800 clogged yesterday and I
cleaned it in much the same way as Tony did. In the states we call it
Windex. I'm not sure that the S800 printhead is the same size as
your's but I used a plastic 5" square food container, put enough water
in it to cover the printhead to the level just below the circuit board
making sure that it covered up to the level inside the head that has
the plungers that contact the cartridges. Then I sprayed some windex
in the water and on the plungers. I went through the procedure 3 times
until the water was clear. I let the printhead air dry after dabbing
off the excess water with some cotton balls. After it was dry and the
cartridges were installed, I ran the head cleaning utility within the
Canon software. The process worked great for me even though Canon
support said that they do not recommend printhead cleaning outside the
printer.

Good Luck,
Len

"Tony" <(E-Mail Removed)> wrote in message news:<XcGdnd_zisMbiSbdRVn-(E-Mail Removed)>...
> "rello" <(E-Mail Removed)> wrote in message
> news:40baf371.22712909@news-server...
> > the removable printhead on my canon s750 is clagged up
> > what is the best method to clean it up
> > i have run the printhead clean utility many times but to no avail
> > i can easily pull out the cradle that holds the carts
> > so how do i remove the gunge in it??
> >
> > relloman
>
>
> Best for the Canon and a clogged printhead ? Small saucer receptacle of warm
> water or Windolene (spray containers of dilute ammonia for cleaning windows)
> to cover just a couple of millimetres leave for a bit and then blot dry on
> tissue. This often works and may need to be repeated.