Did you check to see if there was an I/O address, IRQ
conflict, etc. in Device Manager? Try uninstalling the
USB hub & the CD devices, reboot. Then install the hub
first (reboot), then the CD. I assume you are plugging
the CD drive into the hub externally??? just a guess. It's
also possible that you have a bad hub.
>-----Original Message-----
>This did NOT work. It looks for an updated driver on CD
>1st (obviously can't do that...). It tells me my drivers
>are good?! I tried to uninstall one yesterday, and it
>made no difference. It all started when I tried to add a
>PCI USB hub yesterday... The hub was recognized, but
>then I could not load the driver for it. I unistalled
>the hub and tried to the CD drives again and they were
>dead... Any more ideas?
>>-----Original Message-----
>>Here you go, go "START">RIGHT CLICK "MY
>>COMPUTER">"MANAGE">"DEVICE MANAGER">"DVD/CD ROM
>DRIVES".
>>Now all you have to do is double click on the dvd or cd
>>rom device you want to update the driver on, click on
>>the "DRIVER" tab, then "UPDATE DRIVER". This should
>>update the driver. If that does not work, instead of
>>double clicking on the cd rom or dvd device you want to
>>update, right click on it, delete the device, and
>>restart. Hope this helps.
>>
>>Terry
>>CIS student
>>
>>*******Feel free to email me and let me know if this
>>fixed your issues, I am a CIS student**************
>>>-----Original Message-----
>>>Both my CDRW and DVD ROM drives do not work. I believe
>>>that I have more than likely un-installed some drivers
>>or
>>>interfaces that I needed to read from these drives...
>>>How do troubleshoot and get the correct drivers &
>>>interfaces back??!
>>>
>>>Thanks!!!
>>>.
>>>
>>.
>>
>.
>
|
Similar Threads
