I'm trying to print directly onto a CDR using my i965 and the
CD-LabelPrint software that came with it. I've imported an image,
squared it up and the preview looks fine but whenever I print the
image is 2 cm off center from the top of the cd. Any ideas of where I
might be going wrong ?

Cheers

Jim

that's a hell of a lot, assuming you haven't been messing with the default
disk layout.

Have you tried a basic design within the CD-LabelPrint itself.

"Jim" <(E-Mail Removed)> wrote in message
news:(E-Mail Removed)...
> I'm trying to print directly onto a CDR using my i965 and the
> CD-LabelPrint software that came with it. I've imported an image,
> squared it up and the preview looks fine but whenever I print the
> image is 2 cm off center from the top of the cd. Any ideas of where I
> might be going wrong ?
>
> Cheers
>
> Jim

On 16 Dec 2003 05:21:47 -0800, (E-Mail Removed) (Jim) wrote:

>I'm trying to print directly onto a CDR using my i965 and the
>CD-LabelPrint software that came with it. I've imported an image,
>squared it up and the preview looks fine but whenever I print the
>image is 2 cm off center from the top of the cd. Any ideas of where I
>might be going wrong ?
>
>Cheers
>
>Jim
If the i965 uses a special tray to load the CD prior to printing, it
sounds as if you're not positioning this tray at the correct spot.
The Epson 900 is this way, you have to line up marks on the printer's
bed with the leading edge of the tray, or you get a vertical printing
error such as this.