I have an application that I found out will only run under W2K SP3, after
successfully removing SP4 by means of "Add Remove Programs" and rebooting
the server, typing WINVER still shows SP4. When trying to reinstall SP3 in
the hopes of fixing this I get the message that "Setup has detected that the
Service Pack version of the system installed is newer than the update you
are applying to it. You can only install this update on Service Pack 3."

Does anyone have any clues on tweaking the registry so I can reapply SP3
again?

Would greatly appreciate any feedback.

Thanks in advance.

Answered in .general Friday, April 08, 2005 9:21 PM

These may help.

How to Perform an In-Place Upgrade of Windows 2000
http://support.microsoft.com/support.../Q292/1/75.ASP

What an In-Place Windows 2000 Upgrade Changes and What It Does Not Change
http://support.microsoft.com/default...;en-us;Q306952

Be sure to apply these to your repair install before connecting to any
network.

http://www.microsoft.com/technet/sec.../MS03-043.mspx
http://www.microsoft.com/technet/sec.../MS03-049.mspx

--
Regards,

Dave Patrick ....Please no email replies - reply in newsgroup.
Microsoft Certified Professional
Microsoft MVP [Windows]
http://www.microsoft.com/protect

"Tom H." wrote:
|I have an application that I found out will only run under W2K SP3, after
| successfully removing SP4 by means of "Add Remove Programs" and rebooting
| the server, typing WINVER still shows SP4. When trying to reinstall SP3
in
| the hopes of fixing this I get the message that "Setup has detected that
the
| Service Pack version of the system installed is newer than the update you
| are applying to it. You can only install this update on Service Pack 3."
|
| Does anyone have any clues on tweaking the registry so I can reapply SP3
| again?
|
| Would greatly appreciate any feedback.
|
| Thanks in advance.
|
|