We lost our dirve mappings that were setup using the UNC. I can map
using the IP address.

I went to map a drive and preformed a Browse and nothing shows up
under the Workgroup for the server we want to map to.

Any Ideas?

Thanks

On Aug 11, 1:56*pm, Ron Boetger <rboet...@bblink.net> wrote:
> We lost our dirve mappings that were setup using the UNC. *I can map
> using the IP address.
>
> I went to map a drive and preformed a Browse and nothing shows up
> under the Workgroup for the server we want to map to.
>
> Any Ideas?
>
> Thanks

Check all / any firewall settings. Firewalls can block the "NetBIOS
name resolution" protocol.

I did that and also turned the firewall off. Still no good.

Thanks

On Tue, 11 Aug 2009 06:11:32 -0700 (PDT), smlunatick
<(E-Mail Removed)> wrote:

>On Aug 11, 1:56*pm, Ron Boetger <rboet...@bblink.net> wrote:
>> We lost our dirve mappings that were setup using the UNC. *I can map
>> using the IP address.
>>
>> I went to map a drive and preformed a Browse and nothing shows up
>> under the Workgroup for the server we want to map to.
>>
>> Any Ideas?
>>
>> Thanks
>
>Check all / any firewall settings. Firewalls can block the "NetBIOS
>name resolution" protocol.

Verify that the TCP/IP NetBIOS Helper service is running. Issue the NET
VIEW command and report the output of the command in your next post.

John

Ron Boetger wrote:
> We lost our dirve mappings that were setup using the UNC. I can map
> using the IP address.
>
> I went to map a drive and preformed a Browse and nothing shows up
> under the Workgroup for the server we want to map to.
>
> Any Ideas?
>
> Thanks
>