I seem to have a problem with the vertical alignment on my black
printing. When I do a nozzle check everything is OK except for
results L & M where there is a definite problem. However when I
go into nozzle alignment there is no option to amend these (stops at
k I think). Any ideas how I change these alignments

Updat

I found how to change vertical alignment but not the answer I get
printout like thi

http://i13.photobucket.com/albums/a2...rintquality.jp

instead of a solid block any idea

In message <%Av0f.98545$(E-Mail Removed)>, scottnew
<scott-(E-Mail Removed)> writes

>Update
>
>I found how to change vertical alignment but not the answer I get a
>printout like this
>
>http://i13.photobucket.com/albums/a2...intquality.jpg
>
>instead of a solid block any ideas

Horizontal alignment ?


Cheers, J/.
--
John Beardmore

John any idea how to sort the problem

In message <Ney0f.110410$(E-Mail Removed)>, scottnew
<scott-(E-Mail Removed)> writes

>John any idea how to sort the problem?

Not unless the manufacturer has a utility to sort it. Some of our HP
printers do.


Cheers, J/.
--
John Beardmore

That printout is from a printhead that needs to be replaced.
If it's still under warranty, Canon will replace the printhead at no
cost to you.

Thanks, I finally know, I'll speak to Canon and see about a new prin
hea