I have a Brother HL-1440, trying to install additional memory. I
insert the SIMM at an angle, as the manual indicates (with the
rectangular memory modules facing me), but I'm unable to get it to
lock into place. Any ideas? Thanks!

I had similar trouble. Keep pushing back; eventually it will snap into
place.


On Sat, 15 May 2004 18:46:33 -0700, Steve <(E-Mail Removed)> wrote:

>I have a Brother HL-1440, trying to install additional memory. I
>insert the SIMM at an angle, as the manual indicates (with the
>rectangular memory modules facing me), but I'm unable to get it to
>lock into place. Any ideas? Thanks!

napper <(E-Mail Removed)> wrote:
>>I have a Brother HL-1440, trying to install additional memory. I
>>insert the SIMM at an angle, as the manual indicates (with the
>>rectangular memory modules facing me), but I'm unable to get it to
>>lock into place. Any ideas? Thanks!

>I had similar trouble. Keep pushing back; eventually it will snap into
>place.

Thanks, kinda hate to force it, but maybe that's what it needs...

Before ya force it make sure pin one is at correct end or it will break
socket. I have two 1440s and upgraded both no trouble
Good rugged printer. When ya get a grey background to your prints its your
toner is about out. Refill or replace toner and clean drum and it will be
like new
Tom

"Steve" <(E-Mail Removed)> wrote in message
news(E-Mail Removed)...
> I have a Brother HL-1440, trying to install additional memory. I
> insert the SIMM at an angle, as the manual indicates (with the
> rectangular memory modules facing me), but I'm unable to get it to
> lock into place. Any ideas? Thanks!