lately when i put my Pc to sleep, and come back to it it blue screens when i
turn it back on, then it restarts. I went into eventlog to see if a log has
been made and came up with this
Error source : TClass2k
description: Could not enable interrupts on connected port device
\Device\PointerClass2.
this is the only error i could find and it has the same one everytime it
happens.
After searching the net I think it has something to do with my Genius tablet
but am unsure for i could not find a deffinate answer. And genius dosen't
have any new drivers for it either. haven't tried anything yet and would much
appricate any sugestions.

sounds like an a conflict with the "interrupt settings". Try manually
selecting a configuration that is not in conflict.

In your system devices control panel you might find a question mark on a
port, maybe comm port. If not then manually locate the port for the tablet.
Go to the properties and one of the tabs allows you to configure the
interrupt settings manually......select one from the drop down box that is
not being used for another device. Else, look for an updated driver....


--
~~~~~~~~~~~
"To be a 0 or is it to be the 1 ?
That is the data".......W.Gatespeare


"Tezza" wrote:

> lately when i put my Pc to sleep, and come back to it it blue screens when i
> turn it back on, then it restarts. I went into eventlog to see if a log has
> been made and came up with this
> Error source : TClass2k
> description: Could not enable interrupts on connected port device
> \Device\PointerClass2.
> this is the only error i could find and it has the same one everytime it
> happens.
> After searching the net I think it has something to do with my Genius tablet
> but am unsure for i could not find a deffinate answer. And genius dosen't
> have any new drivers for it either. haven't tried anything yet and would much
> appricate any sugestions.