well, i tried one of the Win98 drivers on from the driverguide website as
that is the OS on the hard drive i'm trying to recover. is that the one I
should be using? if not, which one is preferred?
also, I need to make sure I actually know where to put the drivers. I was
following the instructions on this page:
http://www.pecd.net/modules.php?name...showpage&pid=1
is that what I should be doing?
TB
"ArjanDotOrg" <(E-Mail Removed)> wrote in message
news:(E-Mail Removed)...
>
> T.B. wrote:
> > the thing is that I already downloaded the driver from netgear's site
> and
> > unzipped the driver files into the /network/FA311/files folder for
> PEBuilder
> > and it didn't work.
> >
> > any other suggestions?
> >
> > TB
> >
> > "ArjanDotOrg" <(E-Mail Removed)> wrote in message
> > news:(E-Mail Removed)...
> > >
> > > T.B. wrote:
> > > > i need to add support for Netgear's FA311 NIC to my BartPE admin
> disk
> > > and
> > > > haven't been able to successfully do so. i've found a couple of
> > > sites that
> > > > tell how to do it, followed the instructions but still haven't
> gotten
> > > it to
> > > > work properly.
> > > >
> > > > can anyone give me some hints or point me to a working set of
> > > instructions?
> > > >
> > > > thanks in advance,
> > > >
> > > > TB
> > >
> > > AFAIK you should use the DriverGuide Toolkit
> > > (http://www.driverguide.com) to make a backup of your NIC-drivers
> and
> > > put these files into the Network Driver folder of BartPE.
> > > Good luck!
> > >
> > > Regards,
> > >
> > > Arjan
> > >
>
>
> You'll probably see that the driverbackup that DriverGuide Toolkit
> makes is a lot smaller than the original drivers. That's because DGT
> only extracts the needed files, including the .INF-file.
> Often this works better than using the unzipped drivers.
> Just test it, maybe it works...
>
>
> Regards,
>
> Arjan
>
Similar Threads
