I read the posting about the VBA not working from the ACCDE file and the
solution to go to Debug->Compile and Compile before Making the ACCDE file.
All this I did with no success. VBA Code is still not working.

Any suggestions ????????

Have you enabled the code first? In other words have you set the trusted site
security settings, found by clicking the Windows Globe at the top left hand
side of the database and selecting Access Options at the bottom of the popup
screen. Select Trust Centre from the left hand menu of the next screen. then
select Trust centre Settings, then trusted locations. Add the path to your
database, don' forget to check the allow sub folders if you are pointing to a
group folder additionally you will have to allow my network paths if required.

In Addition, you can show a warning by looking at theessage bar options.
This will show a option box when the data base is opened allowing you to
enable the vb content.

If this has already been set up for you or you have done that, sorry for
misunderstanding the question.

Kindest Regards

Mike B
--
Advice to Posters.
Check your post for replies or request for more information.
Consider providing some feed back to the response you have recieved.
Kindest Regards Mike B


"Sam" wrote:

> I read the posting about the VBA not working from the ACCDE file and the
> solution to go to Debug->Compile and Compile before Making the ACCDE file.
> All this I did with no success. VBA Code is still not working.
>
> Any suggestions ????????