I have a LianLi60 case with 2 front USB ports, and the wires/connections for
these are marked up like so:
One is this:
GND1
SHEILD
DATA - 1
VCC 1
DATA + 1

Then the other one is:
GND 2
DATA -1
VCC 2
DATA + 2
Comparing these to the pins on the board....well how do you do that, when
the board is marked like so:
USB +5
USB P5
USB P5+
GND.... well this one is easy!

Then same again for the other port, but with an extra one for NC...no
connection?

Thanks
--
Bob H
Leeds UK

This should get it working.

VCC 1=USB 5+
DATA - 1=USB P5-
DATA + 1=USB P5+
GND1=GND
SHEILD=NC

VCC 2=USB 5+
DATA - 2=USB P6-
DATA + 2=USB P6+
GND 2=GND

Rob

Bob H wrote:

> I have a LianLi60 case with 2 front USB ports, and the wires/connections for
> these are marked up like so:
> One is this:
> GND1
> SHEILD
> DATA - 1
> VCC 1
> DATA + 1
>
> Then the other one is:
> GND 2
> DATA -1
> VCC 2
> DATA + 2
> Comparing these to the pins on the board....well how do you do that, when
> the board is marked like so:
> USB +5
> USB P5
> USB P5+
> GND.... well this one is easy!
>
> Then same again for the other port, but with an extra one for NC...no
> connection?
>
> Thanks

Thanks Rob, I'll try it and post back

--
Bob H
Leeds UK
"Rob" <(E-Mail Removed)> wrote in message
news:RMeMb.23535$Rc4.88497@attbi_s54...
> This should get it working.
>
> VCC 1=USB 5+
> DATA - 1=USB P5-
> DATA + 1=USB P5+
> GND1=GND
> SHEILD=NC
>
> VCC 2=USB 5+
> DATA - 2=USB P6-
> DATA + 2=USB P6+
> GND 2=GND
>
> Rob
>
> Bob H wrote:
>
> > I have a LianLi60 case with 2 front USB ports, and the wires/connections
for
> > these are marked up like so:
> > One is this:
> > GND1
> > SHEILD
> > DATA - 1
> > VCC 1
> > DATA + 1
> >
> > Then the other one is:
> > GND 2
> > DATA -1
> > VCC 2
> > DATA + 2
> > Comparing these to the pins on the board....well how do you do that,
when
> > the board is marked like so:
> > USB +5
> > USB P5
> > USB P5+
> > GND.... well this one is easy!
> >
> > Then same again for the other port, but with an extra one for NC...no
> > connection?
> >
> > Thanks
>